Skip to main content

How D&R Codes work with Digital Waste Tracking

This article details how D&R codes are extracted for DWT messages

N
Written by Noel

Overview

Digital Waste Tracking (DWT) require a D&R code to be matched up to the waste types in each message. This is controlled through multiple setups in Weighsoft which will link together to match the D&R code to the EWC code of the waste Product.


Setup

The D&R Codes in Weighsoft are found in Administration>Lookups>Waste Activities.

When you go to the screen you will see the available codes as well as columns for EWC Code, outlet Code and Address

in order for a code to be picked up for DWT messages it must be linked to a valid EWC code and a "Waste in" outlet.


DWT Setting

The is a Digital Waste Tracking setting which can play a part in the process.

it is the "Send waste breakdown when available" setting in Administration>Settings>Digital Waste Tracking.

When enabled, if a Transaction has any components then the system will send those to the DWT message rather than the main Waste Type on the transaction.

Example

The below ticket has a waste type of "MIXED CONSTRUCTION WASTE", however the has 4 components of other products

In this case DWt message will be created with 4 waste types - one for each component


​


Process

When the DWT message is generated it will look a the EWC codes set against the Waste Items.

it will then search in the Lookups>Waste Activities screen for a line that matched that EWC code to an Operations (D&R) code and is set against a Waste In outlet.

if the tickets has Components and a match cannot be found in the Waste Activities screen the system will fall back to searching for a match on the main Waste Type set on the Transaction.

Did this answer your question?